Ferrobend | Industrial Flanges Manufacturer & Supplier

DIMENSIONAL DATA

DN	Outside Diameter (D)	Diameter of Bolt Circle (K)	Diameter of Bolt Hole (L)	Bolting Number	Bolting Size	Bore Diameters (B3)	Flange Thickness (C1)	Chamfer (E)
10	90	60	14	4	M12	31	14	3
15	95	65	14	4	M12	35	14	3
20	105	75	14	4	M12	42	16	4
25	115	85	14	4	M12	49	16	4
32	140	100	18	4	M16	59	18	5
40	150	110	18	4	M16	67	18	5
50	165	125	18	4	M16	77	20	5
65	185	145	18	8ᵇ	M16	96	20	6
80	200	160	18	8	M16	108	20	6
100	220	180	18	8	M16	134	22	6
125	250	210	18	8	M16	162	22	6
150	285	240	22	8	M20	188	24	6
200	340	295	22	12	M20	240	24	6
250	405	355	26	12	M24	294	26	8
300	460	410	26	12	M24	348	32	8
350	520	470	26	16	M24	400	35	8
400	580	525	30	16	M27	454	38	8
450	640	585	30	20	M27	500	42	8
500	715	650	33	20	M30	556	46	8
600	840	770	36	20	M33	660	55	8
700	910	840	36	24	M33	-	63	8
800	1 025	950	39	24	M36	-	74	8
900	1 125	1 050	39	28	M36	-	82	8
1000	1 255	1 170	42	28	M39	-	90	8
1200	1 485	1 390	48	32	M45	-	c	-
1400	1 685	1 590	48	36	M45	-	c	-
1600	1 930	1 820	56	40	M52	-	c	-
1800	2 130	2 020	56	44	M52	-	c	-
2000	2 345	2 230	62	48	M56	-	c	-

TABLE NOTE

a) For flanges type 21 the outside hub diameter approximately corresponds to the outside pipe diameter and the nominal value dimensions A, N3 and R1 and their tolerances are included for guidance only.

c) To be specified by the purchaser.

d) Use is limited up to DN 600.

b) According to EN 1092-2 (Cast iron flanges) and EN 1092-3 (Copper alloy flanges), the flanges in this DN and PN may be supplied with 4 holes. Where steel flanges are required with 4 holes, these may be supplied by agreement between flange manufacturer and purchaser.

BS EN 1092-1
Type 04 Loose Plate Flange
with Weld Neck

Need BS EN 1092-1 Type 02 Loose Plate Flanges with Weld Neck Collar for Your Project?

BS EN 1092-1Type 04 Loose Plate Flangewith Weld Neck

Need BS EN 1092-1 Type 02 Loose Plate Flanges with Weld Neck Collar for Your Project?

BS EN 1092-1
Type 04 Loose Plate Flange
with Weld Neck